GE MOTOR MANAGEMENT RELAY 469 Instruction Manual page 27

2 INSTALLATION
4. Once the handle is released from the locking mechanism, the unit can freely slide out of the case when
pulled by the handle. It may sometimes be necessary to adjust the handle position slightly to free the unit.
To insert the unit into the case:
1. Raise the locking handle to the highest position.
2. Hold the unit immediately in front of the case and align the rolling guide pins (near the hinges of the locking
handle) to the guide slots on either side of the case.
3. Slide the unit into the case until the guide pins on the unit have engaged the guide slots on either side of
the case.
4. Grasp the locking handle from the center and press down firmly, rotating the handle from the raised posi-
tion toward the bottom of the unit.
5. When the unit is fully inserted, the latch will be heard to click, locking the handle in the final position.
No special ventilation requirements need to be observed during the installation of the unit.
The unit does not require cleaning.
CAUTION
GE Power Management
Figure 2–8: SLIDE UNIT OUT OF CASE
469 Motor Management Relay
2.1 MECHANICAL
2
2-5