Loading Setpoints From A File; Entering Setpoints - GE 489 Instruction Manual

8 489PC SOFTWARE
An error message will occur when attempting to download a setpoint file with a revision number that does
not match the relay firmware. If the firmware has been upgraded since saving the setpoint file, see Section
WARNING
8.3.5: UPGRADING SETPOINT FILES TO NEW REVISION on page 8–9 for instructions on changing the revi-
sion number of a setpoint file.
The following procedure demonstrates how to load setpoints from a file:
1. Select the File > Open menu item.
2. 489PC will launch the Open window and list all filenames in the 489 default directory with the 489 extension. Select the
setpoint file to download and click OK to continue.
3. Select the File > Send Info to Relay menu item. 489PC will prompt to confirm or cancel the setpoint file load. Click
Yes to update the 489 setpoints.
The following example illustrates how setpoints are entered and edited with the 489PC software.
1. Select the Setpoint > System Setup menu item.
2. Click the Current Sensing tab to edit the
window:
GE Power Management
S2 SYSTEM SETUP\CURRENT SENSING
489 Generator Management Relay
8.3 USING 489PC

8.3.3 LOADING SETPOINTS FROM A FILE

8.3.4 ENTERING SETPOINTS

setpoints. 489PC displays the following
8
8-7