Hardware
3.7.4
Replacing the Display/Display Cable
The following is needed:
– A new display or a new display cable, see
– A torx T10 screwdriver.
– Two plain screwdrivers.
Note:
Make sure you have adequate ESD protection.
E1012 and E1022
To replace the display you will need a new display including display frame, see
the
Available Spare Parts
Follow the steps below:
1. Power off the operator panel.
2. Follow the instructions under
3. Unlock the flex cable connector by pressing the connector flanges towards the
cable and disconnect the flex cable from the CPU board.
The connector must be unlocked on both sides before removing the cable.
4. Loosen the torx screw as shown in the illustration above to release the CPU
board.
Then carefully lift the CPU board.
5. Disconnect the flex cable on the back side of the CPU board and then remove
the CPU board.
6. Push the two plastic sticks towards the top of the panel to unlock the display
from the aluminum casing.
7. Mount the new display unit.
8. Re-assemble the panel in reverse order.
28
Available Spare
section.
Replacing the Rear Cover
flex cable
CPU board
torx screw
display
plastic sticks
Parts.
to remove the rear cover.
Mitsubishi Electric, MA00758A