Start-Up And Configuration; Initializing The Actuator; Configuring The Actuator - Samson TROVIS 5757-7 Mounting And Operating Instructions

7 Start-up and configuration

7.1 Initializing the actuator

The initialization process starts automatically
after the actuator has been connected to the
supply voltage.
The actuator stem extends and the red and
yellow LEDs are illuminated located under-
neath the cover on top of the actuator.
As soon as the actuator stem has reached
the final position, the red LED is turned off.
The yellow LED remains illuminated and indi-
cates that the actuator is ready for use.
Blinking pattern of the red LED:
Zero calibration in progress
On
Off
Blinking pattern of the yellow LED (after
initialization):
Device ON
On
Off
EB 5757-7 EN
7.2 Configuring the actuator
The actuator is configured with the TROVIS-
VIEW software. In this case, the serial
interface on the actuator is used to connect
the actuator to the computer (see the 'Design
and principle of operation' section).
Î Refer to u EB 6661 and u KH 5757-7
for more details on configuration and
operation using TROVIS-VIEW.
Note
The Configuration Manual u KH 5757-7
can be found in the Help menu of the
TROVIS-VIEW software. The manual
contains a detailed description of each
function and parameter.
All the functions and parameters are listed in
the Annex.
Time in s
Time in s
Start-up and configuration
7-1