Camshaft Assembly For The Valves - Perkins UA Workshop Manual

6
700 Series

Camshaft assembly for the valves

To remove and to fit Operation 6-11
Note: The camshaft is supplied as an assembly of camshaft, thrust plate and gear.
Rotate the crankshaft until the marked teeth of the crankshaft gear, the gear for the camshaft for the valves,
and the gear for the camshaft for the fuel injection pump, are aligned with the marked teeth of idler gear.
Check that the camshaft end float is within the limits shown in the relevant Data and dimensions for the "Timing
case and drive assembly" on page 23.
Workshop Manual, TPD 1392E, issue 3 107
This document has been printed from SPI². Not for Resale