Perkins UA Workshop Manual page 173

11
700 Series
8 Remove the fuel injection pump (G).
9 Remove the shim from the fuel pump housing.
10 Remove the stud from the fuel pump housing (H).
11 Clean the flange face of the fuel pump housing.
12 Put the tool into position on the two dowels in the fuel pump housing; the adjustment rod of the tool enters
the pump housing through the hole for the stop solenoid. Fit the two setscrews and tighten them to secure the
tool to the fuel pump housing (J).
Continued
Workshop Manual, TPD 1392E, issue 3 161
This document has been printed from SPI². Not for Resale