Perkins UA Workshop Manual page 150

10
700 Series
To inspect Operation 10-8
Notes:
l Fit the outer rotor and check the outer rotor to body clearance with a feeler gauge.
l Check the inner rotor to outer rotor clearance.
l Check the rotor end-float with a straight edge and a feeler gauge.
For the above clearances refer to the relevant Data and dimensions for the "Lubrication system" on page 27.
Service operations
Remove the crankshaft pulley, see Operation 5-1.
Remove the timing case, see Operation 6-2.
Remove the lubricating oil pump, see Operation 10-7.
138 Workshop Manual, TPD 1392E, issue 3
This document has been printed from SPI². Not for Resale