Screens - Agilent Technologies VS Series Operation Manual

VS Series Helium Mass Spectrometer Leak Detectors

2.2 Screens

The leak detector display is used for the initial set-up and configuration of the leak detector.
Once the leak detector is set up and configured for a specific application, basic operation is
controlled primarily using the TEST and VENT buttons on the leak detector and the Home
screen Zero button (Section 2.2.2 "Home Screen" on page 2-7).
2.2.1 Basic Functions
Table 2-1 explains the basic on-screen functions used to enter or manipulate values.
Item
CALIBRATE
DONE
8.6E-07
EXTERNAL LEAK VALUE:
ATM-CC/SEC
1 2 3
5 6 7
* 9 0
OK
Table 2-1 Screen Basic Functional Items
Using the Calibrate button as an example, LEDs light when
the button is selected and activated.
Press Done to exit a screen.
Using a leak value as an example, press the value button and
a keypad appears for entering values.
Using External Leak Value as an example, these keypads
appear wherever values are entered. Enter the values with
5.0E-9
the keypad and press OK.
4 CLEAR
The keypad values are dictated by the data required on the
parent screen. For example, if entering a leak rate value, the
8 CANCEL
system places an E or - sign in for the exponent.
-/+ OK
Press:
❑
❑
❑
Appears on screens more than one level from the Home
screen. Press this button to return directly to the Home
screen.
Used to increment/decrement values.
Saves all values on the screen and exits to the next higher
screen.
Moves you between menu selection screens when there is
more than one screen of choices.
Clear to clear the display.
Cancel to close the keypad screen without saving.
OK to close the keypad and save.
Function
2-5