Agilent Technologies VS Series Operation Manual page 17

VS Series Helium Mass Spectrometer Leak Detectors
Power and Static Sensitivity
xvii
The Wireless Remote complies with Part 15 of the FCC Rules.
WARNING
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that
may cause undesired operation.
To satisfy FCC RF exposure requirements for mobile type transmit-
ting devices, maintain a separation distance of 20 cm or more
between the antenna of the Wireless Remote and persons during
operation, with exception of hands wrist, feet, and ankles. To
ensure compliance, operations at closer distance than this distance
are prohibited.
Maintain a separation distance of 20 cm or more between the oper-
ator and the RF antenna of the VS Series leak detector with a wire-
less base station.
Use only approved type of antennas for:
CAUTION
Wireless Remote: Centurion, Model WCP2400-MMCX2,
❑
www.centurion.com.
VS Series Leak Detector Wireless Base Station, Nearson,
❑
Model S181FL-5-RMM- 2450S, www.nearson.com
Depending on the unit configuration ordered, the mains power
WARNING
supply requirements for VS Series leak detectors are:
100 VAC, 50 Hz, 20 A
❑
115 VAC, 60 Hz, 20 A or
❑
230 VAC, 50/60 Hz, 12 A
❑
Before powering the unit for the first time, verify that the unit is
configured to operate for the local mains supply voltage.