Agilent Technologies VS Series Operation Manual page 16

VS Series Helium Mass Spectrometer Leak Detectors
WARNING
CAUTION
LCD Display
WARNING
CAUTION
Radio
Equipment tightness is guaranteed for normal operating
conditions when the equipment leaves the factory. It is the
user's responsibility to maintain the level of tightness,
particularly when pumping dangerous products.
The performance and operating safety of this equipment can
only be guaranteed if it is operated according to normal
conditions of use.
Allow at least 4" of clearance adjacent to the ventilation slots at
the front, sides and back of the equipment enclosure.
Allow sufficient room for the operator to safely maneuver to
perform testing.
If the LCD display breaks, avoid getting any liquid crystal in mouth
or eyes. If it gets on the operator hands, feet or clothing, wash it
immediately with soap and water.
Do not apply excessive pressure to the LCD display as this may
cause smears.
In general, the lower the temperature, the longer it takes the LCD
display to turn on. Performance of the LCD display may deteriorate
in low temperature.
The Wireless Remote Control is built around an Aerocomm, model
AC4424-100, RF transceiver module operating in 2.4 GHz ISM
band. The same type of the RF module is built in a VS Series Leak
Detector Wireless Base Station PCB and Wireless Remote unit (see
VS Series Leak Detector Wireless Remote Operational Manual
(6999099945A)).
Agency Identification Numbers for Aerocomm, Model
AC4424-100:
US/FCC ID: KQL-AC4424
❑
CAN/IC: CAN2268C391190A
❑
EUR/EN: CE
❑
are also applied to the Agilent's Wireless Remote and VS Series
Leak Detector Wireless Base Station, when the units are used the
approved antennas.
xvi