Agilent Technologies VS Series Operation Manual page 83

VS Series Helium Mass Spectrometer Leak Detectors
Table 2-6 System Information Screen Conditions (Continued)
Condition
Ion Source Filament
See Section 3.1.2 "Manual Tuning"
on page 3-7.
Gain
Leak Rate Range
See Section 2.2.4.4 "Leak Rate
Ranging" on page 2-25.
Range Stop
See Section 2.2.4.4 "Leak Rate
Ranging" on page 2-25.
Reject Set Point
See Section 2.2.4.2 "Reject and
Audio Set Points" on page 2-19.
Software Version and
Agilent Web site
Split Flow
See Section 2.2.4.1 "Calibration
Set-Up" on page 2-17.
Vent Lockout Status
See Section 2.2.4.7 "Control Panel
Access" on page 2-32.
Display
Filament 1 Off
Filament 1 On
Filament 2 Off
Filament 2 On
Gain (Gain Value)
Auto Ranging
Manual Ranging
Range Stop -[Exp]
Reject# 1,2,3,4 Active Reject set points displayed are active;
Description
Filament 1 is selected and not lit.
Filament 1 is selected and lit.
Filament 2 is selected and not lit.
Filament 2 is selected and lit.
Displays the gain that applied to the
leak rate. The actual helium signal is
multiplied by the gain value to read
the correct, calibrated leak rate.
System is set to auto range through
the leak rate scale.
System is set for manual range control.
System is set to display the most
sensitive leak rate range, 10
The range stop line shows only if
range stop is on.
this line is blank when all set points
are disabled or inactive.
Shows the software version of the CPU
board (L version) and software version
of the display board (D version). Also
shows the Agilent web address for
customer use.
See the back cover of this manual for a
listing of our sales and service offices.
Shows split flow, only if the feature is
turned on. To change the status, go to
the Advanced Parameters screen.
Shows the status of the vent lockout
feature only if it is on. To change the
status of the vent lockout feature, go
to the Control Panel access screen.
[Exp]
.
-
2-31