Function View For Iec 61850 In Pcm600 - ABB Relion 615 Series Engineering Manual

1MAC108982-MB A
7.2.2
615 series ANSI
Engineering Manual
The concept is based on sending a multicast over the Ethernet. Whoever needs the
information, detects the telegram by its source address, reads the telegram and deals
with it. The telegrams are multicast sent and not acknowledged by the receiver.
Data-set
LN
LN
LN
LN
LN
LN
IED 1
IEC05000830 V1 EN
Figure 68: IEC 61850: horizontal communication principle, an example of three
IEDs where each IED communicate with all others
When a GOOSE message is to be sent, it is defined by configuring the data set with the
defined trigger option and GoCB. This engineering process is done in a station
configuration tool, for example, CCT600. The task involves configuring lists with the
signal, value and quality (data attributes) that belong to the GOOSE message data set.
In the opposite direction, the standard only defines the IED as a receiver of a GOOSE
message. How the GOOSE input signals are handled must be defined in the IED
application configuration. The SCD file generated by CCT600 (or any other station
configuration tool) contains the GOOSE data sets as input data. The input data must be
connected to a GOOSE receive function blocks in the Signal Matrix tool.

Function view for IEC 61850 in PCM600

The IED design is directly based on IEC 61850. Thus, the function blocks in PCM600
tool use IEC 61850 logical node naming for function blocks. This relation is
automatically handled by the PCM600 tools.
The concept in the IED is such that the IEC 61850 data for each function instance is
available in the data model, even when the function is not used in the application. This
means that it is not necessary to handle any instance information for the functions
regarding IEC 61850.
IEC 61850 communication engineering
IEC 61850 Subnetwork
Data-set
LN
LN
LN
LN
IED 2
Section 7
Data-set
LN
LN
LN
LN
LN
IED 3
en05000830.vsd
101