Adding Symbols Into A Display Page - ABB Relion 615 Series Engineering Manual

Section 6
LHMI engineering
6.1.1.9
92
GUID-A58439A5-575C-4EED-A5A9-77FDECAA9D21 V1 EN
Figure 61: Graphical Display Editor: drawing a busbar and placing busbar
junctions
3. Add a link between one Busbar Junction point and the corresponding symbol or
junction point.

Adding symbols into a display page

1. Prepare the body of the single-line diagram by locating symbols to the wanted
positions on the display.
2. Place the apparatus or transformer symbols into a raster box by dragging-and-
dropping.
3. Place the connection symbols into a raster box by dragging-and-dropping.
4. Place the junction points.
Do not connect two symbols directly to each other; instead, add a junction
between them.
5. Use the coordinates as symbols for adjusting the placement.
Place Busbar Junctions into
display page
1MAC108982-MB A
Select Busbar Junction
symbol and use Rotate
command from toolbar to get
the busbar end to the margin
615 series ANSI
Engineering Manual