Storage Commands - Oracle X6-2-HA Deployment And User's Manual

Task
Update an existing network
configuration.
Delete a network.
Configure the network after
either replacing a network
card or swapping the public
network from copper to fiber
and vice versa.
Configure any unconfigured
public networks in bare metal,
Domain 0, and ODA_BASE.
Use after replacing InfiniBand
10GbE SFP+ cards (fiber)
cards and before deployment
to unconfigure IB setup and
configure fiber cards.
Create a VLAN
Delete a VLAN
Display details about the
VLAN

Storage Commands

ODACLI and OAKCLI commands for configuring and managing storage.
Task
Check the cable connections
between the system
controllers and the storage
shelf, as well as the cable
connection to the storage
expansion shelf (if one is
installed).
Expand storage.
Display the status of a single
disk or of all disks on the
system.
List configured diskgroups or
display a specific Oracle
Automatic Storage
Management (Oracle ASM)
diskgroup configuration.
Display details of the
controller.
Display the RAID SYNC
status.
Command to Run on the
DCS Stack
odacli update-network
odacli delete-network
odacli configure-
network
Not Applicable
Not Applicable
odaadmcli create vlan
odaadmcli delete vlan
odaadmcli show vlan
Command to Run on the
DCS Stack
odacli validate-
storagetopology
odaadmcli expand
storage
odaadmcli show disk
odaadmcli show
diskgroup
odaadmcli show
controller
odaadmcli show
raidsyncstatus
Appendix A
Storage Commands
Command to Run on the
OAK Stack
Not Applicable
Not Applicable
oakcli configure
network
oakcli configure
additionalnet
oakcli configure
ib2fiber
Not Applicable
Not Applicable
Not Applicable
Command to Run on the
OAK Stack
Not Applicable
oakcli expand storage
oakcli show disk
oakcli show diskgroup
oakcli show controller
oakcli show
raidsyncstatus
A-5