Oracle X6-2-HA Deployment And User's Manual page 346

Note:
Oracle recommends using the oakcli configure firstnet command
only one time on Oracle Database Appliance. Subsequent use after
configuring the initial network can cause unpredictable changes to your
network settings.
oakcli configure network
Use the oakcli configure network command to configure the network after either
replacing a network card or swapping the public network from copper to fiber and vice
versa. The meaning of the command changes depending on which parameter you
use.
Syntax
oakcli configure network [-changeNetCard|-publicNet][-h]
Parameters
Parameter
-changeNetCard
-publicNet
-h
oakcli configure oda_base
Use the oakcli configure oda_base command to change the CPU core count
assigned to ODA_BASE, add or remove virtual local area networks assigned to
ODA_BASE, and adjust resource allocation among user domains and between
ODA_BASE and other user domains.
You must restart the domain for the resource allocation change to take effect.
Syntax
oakcli configure oda_base
Description
Configures the network card after it has been replaced. You
must run the
oakcli configure network -changeNetCard
command on each node if the network card was replaced. This
parameter is supported on all Oracle Database Appliance
hardware models. This command must be executed from Dom0
on virtualized platforms.
Configures the network after you have swapped the public
network from copper to fiber and vice versa. You must run the
oakcli configure network -publicNet
node, and this requires the stack to be down. The stack includes
GI and RDBMS. If you are using Oracle Database Appliance
Virtualized Platform, the virtual machines must be down. The
virtual machines may need some configuration changes,
especially if they are using VLANs. This parameter is supported
only on Oracle Database Appliance X4-2 hardware models.
(Optional) Display help for using the command.
Chapter 14
oakcli configure commands
command on each
14-11