YASKAWA iQpump1000 Installation & Start?Up Manual page 45

Table i.16 illustrates how to set the Real-Time Clock at initial power-up of a new drive.
Turn the power on. The Real Time Clock Adjustment Display will appear. Use the right arrow
1 key to select the desired digit, then set the correct date and 24-hour clock time using the up and
down arrow keys.
After entering the Real-Time Clock data, press the ENTER key to save the changes.
2 The display will indicate "Entry Accepted" and return to the initial display in step 3 and the alarm
LED will be OFF.
3 Initial display.
n Manual Clock Adjustment by Setting o4-17 to 1
The following actions are possible in the Clock Adjustment Mode:
• Set the current time
• Check the time set to the drive Real-Time Clock
Table i.17 illustrates how to set the Real-Time Clock manually.
The "Clock Not Set" display will appear if the Real-Time Clock data is not entered within 30
1
seconds of power-up of a drive with an HOA operator that has not yet been set.
Use the up and down arrow keys to scroll through display menu until the screen shows
2
"Programming".
3 Press the ENTER key to enter select the parameter setting mode.
4 Use the up and down arrow keys to scroll through display menu until parameter o4-17 appears.
YASKAWA TOEP YAIP1W 02E YASKAWA AC Drive - iQpump1000 Installation & Start-up Guide
Table i.16 Clock Adjustment Procedure at Power-up of a New Drive
Procedure
Table i.17 Manual Clock Adjustment Procedure by Setting o4-17 to 1
Procedure
i.5 Start-Up Programming and Operation
YYYY/MM/DD HH:MM
20 1
Second per month
+ 0 sec
- MODE -
U5-99= 0.0PSI
U1-02= 0.00Hz
U1-91= 0.0PSI
- MODE -
Clock Not Set
- MODE -
HOME
- PRMSET - PRG
Select Language
HOME
- PRMSET - PRG
HOME
Display
ALM ALM
0/01/01 00:00
ALM
Entry accepted
DRV Rdy
Auto Setpoint
LSEQ
LREF
<-MONITOR->
Display
ALM ALM
DRV Rdy
Press F2 to Set
FWD
DATA
ALM
PRG
Programming
FWD
ALM ALM
Initialization
A1-00 = 0
FWD DATA
ALM ALM
Maintenance
o4-17 = 0
Set time
FWD
DATA
45