YASKAWA iQpump1000 Installation & Start?Up Manual page 47

u
HOA Keypad Keys and Displays
No. Display
F1
Function Key
1
(F1, F2)
F2
2 ESC Key
ESC
3 RESET Key
4 AUTO Key
AUTO
5 Up Arrow Key
6 Down Arrow Key
7 OFF Key
OFF
8 ENTER Key
9 HAND Key
HAND
10 AUTO Light
AUTO
11 HAND Light
HAND
12 ALM LED Light
YASKAWA TOEP YAIP1W 02E YASKAWA AC Drive - iQpump1000 Installation & Start-up Guide
1
2
3
10
Figure i.26 Keys and Displays on the HOA Keypad
Name
The functions assigned to F1 and F2 vary depending on the currently displayed menu. The name of
each function appears in the lower half of the display window.
• Returns to the previous display.
• Moves the cursor one space to the left.
• Pressing and holding this button will return to the Frequency Reference display.
• Moves the cursor to the right.
• Resets the drive to clear a fault situation.
Selects the source of Run command and frequency reference.
• Set the drive to AUTO mode.
• Run command input source depends on b1-02.
• Frequency reference input source depends on b1-01.
Scrolls up to display the next item, selects parameter numbers, and increments setting values.
Scrolls down to display the previous item, selects parameter numbers, and decrements setting values.
Follows the stopping method set in b1-03 to stop drive operation.
Note: The OFF key is DISABLED during Emergency Override.
• Enters parameter values and settings.
• Selects a menu item to move between displays.
The drive runs at a selectable frequency reference source as set by P5-01.
• Set the drive to HAND mode.
• When P5-03 is set to 1, HAND and AUTO mode can be switched while the drive is running.
Lit while the drive is in AUTO mode.
Lit while the drive is in HAND mode.
Lit when the drive detects an alarm or error.
i.5 Start-Up Programming and Operation
12
ALM
DIGITAL OPERATOR JVOP-183
11
F1 F2
9
M M
ESC
HAND
8
RESET ENTER
AUTO OFF
4 5 6 7
Function
47