Removing And Installing Drive Cage - Siemens SIMATIC IPC647D Operating Instructions Manual

Expanding and assigning parameters to the device
6.6 Drives and storage media
6.6.2

Removing and installing drive cage

Requirement
● The device is open, see the section "Open the device. (Page 63)".
● Applies for vibration-damped drive cage:
The bus frame has been removed, see chapter "Removing and installing bus frame
(Page 68)".
● 1 T10 screwdriver
Procedure
Read the section "ESD guideline (Page 119)".
Removal
1. Remove the marked screws.
2. Remove the marked screws.
3. Note the positions of the marked
4. Slide the drive cage toward the
74
SATA connector.
Press the unlock mechanism of the
connector shown on the right in the
figure and pull off the connector.
Pull off the power supply connector
of the Slimline drive marked on the
right, if a Slimline drive exists.
power supply until it is released
from the front frame and remove
the drive cage from the device.
Operating Instructions, 01/2014, A5E32996306-AA
SIMATIC IPC647D