Identification Data Of The Device - Siemens SIMATIC IPC647D Operating Instructions Manual

Installing and connecting the device
3.1 Preparing for installation
7. Please keep the enclosed documentation in a safe place. It belongs to the device. You
need the documentation when you commission the device for the first time.
8. Write down the identification data of the device.
3.1.2

Identification data of the device

The device can be clearly identified with the help of this identification data in case of repairs
or theft.
Noting down the device identification data
Enter the following data in the table below:
Serial number
Order no.
Microsoft Windows Product Key
Ethernet 1 address
Ethernet 2 address
CP 1616 onboard layer 2
30
NOTICE
Damage from condensation
If the device is subjected to low temperatures or extreme fluctuations in temperature
during transportation, for example in cold weather, moisture could build up on or inside
the HMI device.
Moisture can result in short-circuits in electrical circuits and damage the device.
In order to prevent damage to the device, proceed as follows:
• Store the device in a dry place.
• Bring the device to room temperature before starting it up.
• Do not expose the device to direct heat radiation from a heating device.
• If condensation develops, wait approximately 12 hours or until the device is
completely dry before switching it on.
S VP ...
6AG4112-2 ...
Operating Instructions, 01/2014, A5E32996306-AA
SIMATIC IPC647D