Removing And Installing A Tray From/In The Drive Cage - Siemens SIMATIC IPC1047E Operating Instructions Manual

6.5.3.2

Removing and installing a tray from/in the drive cage

Requirement
• The device is open; see section "Open the device. (Page 53)".
• 1 soft, grounded mounting base
Procedure
Removal
1. Detach the marked connection
cables from the relevant drive.
2. Press the side rails of the tray
inwardly and simultaneously lift
them up and out of the drive
cage.
3. Place the tray on the mounting
base.
Installation
Proceed in the reverse order for the installation. Ensure that the tray latches in the bottom of
the drive cage.
SIMATIC IPC1047E
Operating Instructions, 03/2021, A5E50259546-AA
Expanding and assigning parameters to the device
6.5 Drives
73