Removing The Op - Siemens SIMATIC IPC647D Operating Instructions Manual

Removing the bus board
1. Remove all 5 expanding rivets with which the bus board
2. Use a screwdriver to press on the end of the expansion
Procedure
Installation
Install the device in reverse order. Use only new expansion rivets to mount a bus board.
7.3.7

Removing the OP

Requirement
● The device is fully disconnected from the mains voltage, see chapter "Switching off the
● The device is open, see the section "Open the device. (Page 63)".
● The bus frame has been removed, see chapter "Removing and installing bus frame
● 1 operator panel
● 1 crosstip screwdriver
Procedure
Read the section "ESD guideline (Page 119)".
SIMATIC IPC647D
Operating Instructions, 01/2014, A5E32996306-AA
is fastened to the middle rack of the bus frame.
rivet until the expansion rivet can be freely moved.
device (Page 51)".
(Page 68)".
Device maintenance and repair
7.3 Removing and installing hardware
95