Siemens SIMATIC IPC647D Operating Instructions Manual page 179

On-screen error messages
On-screen error message
Error - Keyboard error
Error - Keyboard controller error
or no keyboard present
Error - Keyboard controller error
Error - System halted - harddisk
drive (HDD) locked!
Error - No MPI/DP interface
detected
Error - PCH softstrap
programming error: Riser card
may not work correctly
Error - PCH softstrap can't be
programmed, descriptor locked:
Riser card may not work
correctly
Error - SPI regions are not
locked (ME unlocked)
Error - Riser card Taufe does
not match connected hardware
configuration
Error - Taufe configuration not
present (Platform = Unknown)
Warning - Manufacturer mode
enabled
System RAM Failed at offset
Error - CMOS battery failed
Error - SMART failure detected
on HDD
No bootable device -- Please
restart system
Error - Realtime clock has lost
power
Screen remains dark - cursor
flashes at top left
SIMATIC IPC647D
Operating Instructions, 01/2014, A5E32996306-AA
Meaning / tip
Check whether the keyboard is properly connected.
Check whether a functioning keyboard is properly connected. If
this is the case, contact your technical support team.
Keyboard error Contact your Technical Support.
Turn off device, remove, HDD interlock and reboot once again.
PROFIBUS interface defective Contact your Technical Support.
Contact your Technical Support.
Contact your Technical Support.
Contact your Technical Support.
Contact your Technical Support.
Contact your Technical Support.
Contact your Technical Support.
Memory error Contact your Technical Support.
Battery on the CPU module defective or empty Contact your
Technical Support.
Hard disk fault: A fault threshold specified by the manufacturer has
been exceeded. Operation of the hard disk is unreliable. The hard
disk has to be replaced. Contact your Technical Support.
Possible causes:
No operating system installed
•
Wrong drive addressed (disk in drive A/B)
•
Incorrect active boot partition
•
Incorrect drive entries in SETUP
•
HDD not connected / defective
•
Timer block error Contact your Technical Support.
A data carrier is inserted in the ODD drive. In this case it can take
several minutes until the BIOS power up is continued.
Technical specifications
8.6 BIOS description
179