Siemens SIMATIC IPC647D Operating Instructions Manual page 72

Expanding and assigning parameters to the device
6.5 Expansion cards
7. Press the retainer onto the
8. Cut off the protruding part of the
9. Insert the front slot plate again.
Removal
For installation, follow the steps for removal in reverse order.
The retainer can only be moved in the direction of the expansion card. To remove the
retainer open the longitudinal side of the bus frame and pull out the retainer inwards.
Further procedure
1. Install the bus frame into the device in accordance with the chapter "Removing and
installing bus frame (Page 68)".
See also
System resources (Page 159)
BIOS description (Page 169)
Bus board (Page 153)
Bus board models (Page 153)
72
expansion card. But only so that
the retainer touches the expansion
card and does not damage it.
While doing this, adjust the
expansion card so that it fits into
the slot of the retainer. Pay
attention to the notch of the
expansion card.
retainer as shown.
Do not leave any remnants jutting
out.
Swivel the top side of the bus frame
back into the original position and
secure the top side of the bus
frame with the marked screw.
Operating Instructions, 01/2014, A5E32996306-AA
SIMATIC IPC647D