Replacing The Processor - Siemens SIMATIC IPC647D Operating Instructions Manual

4. Slide the motherboard carefully inwards until the D-sub sockets have loosened from the
5. Lift the motherboard carefully out of the housing.
Installation
To install the fan, follow the steps for removing it in reverse order.
Further procedure
1. Install the bus frame.
2. Close the device.
See also
Connection information (Page 34)
ESD guideline (Page 119)
7.3.10

Replacing the processor

Requirement
● The device is open, see the section "Open the device. (Page 63)".
● The bus frame has been removed, see chapter "Removing and installing bus frame
● The processor cooler has been removed, see chapter "Removing and installing the
● 1 approved processor
SIMATIC IPC647D
Operating Instructions, 01/2014, A5E32996306-AA
rear panel.
NOTICE
Damage to the motherboard
Components can be damaged when removing the motherboard.
• Proceed slowly and carefully when moving and removing the motherboard.
• Ensure that the bottom of the motherboard does not contact projecting housing parts
when sliding it.
(Page 68)".
processor cooler (Page 97)".
Only an approved processor is permitted to be installed on the motherboard of the
device. If the processor type is changed, the BIOS must be updated so that the suitable
microcode is loaded. Information about original spare parts for SIMATIC IPCs is available
on the Internet at:
– SIMATIC IPC after-sales information system (http://www.siemens.com/asis)
– Contacts (http://www.siemens.com/automation/partner)
Device maintenance and repair
7.3 Removing and installing hardware
101