Removing And Installing A Tray From/In The Drive Cage; Removing And Installing 3.5" Drives From/In Tray - Siemens SIMATIC IPC1047 Operating Instructions Manual

Expanding and assigning parameters to the device
6.4 Drives
6.4.2

Removing and installing a tray from/in the drive cage

Requirement
● The device is open; see section "Open the device. (Page 52)".
● 1 soft, grounded mounting base
Procedure
Read section "ESD guideline (Page 103)".
Removal
1. Detach the marked connection
cables from the relevant drive.
2. Press the side rails of the tray
inwardly and simultaneously lift
them up and out of the drive
cage.
3. Place the tray on the mounting
base.
Installation
Proceed in the reverse order for the installation. Ensure that the tray latches in the bottom of
the drive cage.
6.4.3

Removing and installing 3.5" drives from/in tray

Requirement
● The tray has been removed, see section
"Removing and installing a tray from/in the drive cage (Page 56)".
● 1 drive
● 1 soft mounting base
56
Operating Instructions, 09/2018, A5E45118479-AA
SIMATIC IPC1047