Removing And Installing Hardware; Drives; Removing And Installing The Drive Cage - Siemens Simatic IPC547E Operating Instructions Manual

7.4

Removing and installing hardware

7.4.1

Drives

7.4.1.1

Removing and installing the drive cage

Requirement
● The device is fully disconnected from the mains voltage, see chapter "Switching off the
● The device is open, see the section "Open the device (Page 62)".
● The front door is open, see chapter "Opening the front door (Page 61)".
Procedure
Removal
1. Remove the highlighted screws.
2. Remove the accessible power supply and data cables from the drives.
SIMATIC IPC547E
Operating Instructions, 02/2014, A5E32317120-AB
device (Page 53)".
Device maintenance and repair
7.4 Removing and installing hardware
77