Com, Dp, Dvi/Vga, Ps/2 And Audio Lines; Multi-Monitoring - Siemens SIMATIC IPC647D Operating Instructions Manual

Installing and connecting the device
3.3 Connecting the device
3.3.6.2

COM, DP, DVI/VGA, PS/2 and audio lines

Cable ties that can be loosened for strain relief at the interfaces are enclosed in the
accessory kit. These cable ties can be mounted to the rear panel.
Procedure
1. Push a cable tie into the device rear panel at the marked point.
The figure shows the correct cable tie mounting position.
2. Secure the cables by means of the cable tie.
3.3.7

Multi-monitoring

You can operate up to five monitors simultaneously at the interfaces of the integrated
graphics controller in combination with the optional graphics card. Parameter assignment is
performed by means of the Control Panel in Windows.
The following monitors can be operated simultaneously on the motherboard:
● 2 × DisplayPort, 1 × DVI
● 2 × DisplayPort, 1 × VGA
● 1 × DisplayPort, 1 × DVI via DisplayPort-DVI adapter, 1 × DVI
● 1 × DisplayPort, 1 × VGA via DisplayPort-VGA adapter, 1 × DVI/VGA
Note
The motherboard supports up to one additional DVI monitor if it is connected by means of a
passive DisplayPort-DVI adapter.
44
Operating Instructions, 01/2014, A5E32996306-AA
SIMATIC IPC647D