Connecting An Ac Power Supply - Siemens SIMATIC IPC647D Operating Instructions Manual

Installing and connecting the device
3.3 Connecting the device
3.3.4.2

Connecting an AC power supply

Requirement
● The device is fully disconnected from the mains voltage, see chapter "Switching on the
device (Page 46)".
● 1 power cable
● 1 power plug latch from the accessory kit
● 1 T10 screwdriver
Procedure
Mounting
1. Set the on/off switch
2. Remove the screws
3. Plug the power cable plug
4. Plug the power cable plug into the power
5. Slide the power plug latch
6. Secure the power plugs, if necessary, to prevent the power cables from becoming loose
7. Set the on/off switch
Removal
For installation, follow the steps for removal in reverse order.
Risk of fire
If the power plug is secured with a clamp, the power outlet must be freely accessible to
allow the device to be easily removed from the mains.
38
①
This prevents an automatic starting of the
device when plugging in the power cable.
③
outlet.
outlet.
accidentally: Secure the power plug latch with the screw
①
The yellow power LED on the front panel of the device lights up.
WARNING
to position '0'.
.
②
into the power
④
over the plug.
to position 'I'.
③
.
Operating Instructions, 01/2014, A5E32996306-AA
SIMATIC IPC647D