Removing And Installing An Ssd; Removing And Installing An Ssd From A Tray - Siemens SIMATIC IPC647D Operating Instructions Manual

Replacing a defective hard disk drive in the RAID system
1. Determine which hard disk was reported by the RAID software as defective.
2. Replace the defective hard disk.
3. Replace the defective hard disk with a hard disk of the same type and capacity.
Information about the recovery of the RAID system is available in the section "Integrating a
new hard disk into the RAID system".
6.6.8

Removing and installing an SSD

6.6.8.1

Removing and installing an SSD from a tray

Requirement
● The tray has been removed, see chapter "Removing and inserting the tray from the
● The connecting cables have been removed from the SSD.
● 1 soft mounting padding
Procedure
Observe the chapter "ESD guideline (Page 119)".
Removal
1.
2.
Installation
For installation, follow the steps for removal in reverse order. Use only the original screws
during installation. Position all screws first and do not tighten them until all screws are
installed in the thread.
SIMATIC IPC647D
Operating Instructions, 01/2014, A5E32996306-AA
removable drive bays (Page 77)".
Place the tray as shown on the
mounting padding.
Remove the marked screws.
Expanding and assigning parameters to the device
6.6 Drives and storage media
81