Siemens SIMATIC IPC647D Operating Instructions Manual page 71

Procedure
Installation
1. Remove the marked screw.
2. Swing the top edge of the bus
3. If you want to install the expansion
4. Insert the expansion card into the
5. If required, fasten the shown
6. Insert the retainer
SIMATIC IPC647D
Operating Instructions, 01/2014, A5E32996306-AA
frame towards the arrow direction
and remove the front slot plate.
card into the rear slot, remove the
marked screw and then the rear
slot plate.
slot in the arrow direction.
Slide the expansion card into the
slot until it stops without being
skewed.
Secure the expansion card at the
marked point with the
corresponding screw.
support bracket with 2 expansion
rivets to the bus frame, in particular
at low-profile expansion cards.
①
through one
of the marked guide slots
If possible, use the guide slot
closest to the edge-socket
connector.
The retainer can only be moved in
the direction of the expansion card.
The retainer latches into the
selected position.
If you want to change the position
subsequently, you have to open the
top edge of the bus frame.
Expanding and assigning parameters to the device
②
.
6.5 Expansion cards
71