Removing And Installing A Drive From A Drive Cage - Siemens SIMATIC IPC647D Operating Instructions Manual

Hide thumbs Also See for SIMATIC IPC647D:
Table of Contents

Advertisement

6.6.6

Removing and installing a drive from a drive cage

This chapter describes the removal and installation of the following drive types from the drive
cage or the vibration-damped drive cage:
● Hard disk drive
● Removable drive bay
● DVD drive
Removal and installation of a Slimline DVD drive is carried out analog.
Requirement
● The drive cage has been removed, see chapter "Removing and installing drive cage
● The drive fan has been removed, see chapter "Removing and installing drive fans
● The connecting cables have been removed from the drive.
Procedure
Read the section "ESD guideline (Page 119)".
Removal
1. Position the drive cage as shown.
2. Remove the marked screws of the
4. Pull the removable drive bay out of
Installation
To install the fan, follow the steps for removing it in reverse order. Use only the original
screws during installation.
SIMATIC IPC647D
Operating Instructions, 01/2014, A5E32996306-AA
(Page 74)".
(Page 75)".
both sides of the drive cage.
the drive cage in the direction of the
arrow.
Expanding and assigning parameters to the device
6.6 Drives and storage media
79

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents