YASKAWA PROFIBUS-DP SI-P3 Technical Manual page 19

2.
Shut off power to the drive, wait the appropriate amount of time for voltage to dissipate, then remove the front
cover (D).
Refer to the manual packaged with the drive for details on cover removal.
NOTICE: Damage to Equipment. Observe proper electrostatic discharge (ESD) procedures when handling the option, drive, and
circuit boards. Failure to comply could cause ESD damage to circuitry.
Figure 13
3.
Carefully remove the LED Status Ring board (G) and place it on the right side of the drive using the temporary
placement holes.
Refer to the manual packaged with the drive for details on removing the LED Status Ring board.
NOTICE: Do not remove the LED Status Ring board cable connector. Failure to comply could cause erroneous operation and damage
the drive.
Figure 14
YASKAWA ELECTRIC SIEP C730600 82D YASKAWA AC Drive Option SI-P3 Technical Manual
Move the keypad connector to the holder on the
A1000
drive after removing the keypad and before removing
the front cover. Insert the keypad connector tab into
the holder when installing the keypad connector to
the holder.
Keypad connector tab
Keypad connector
Figure 13 Remove the Front Cover and Keypad
G
Drive front view
Figure 14 Remove the LED Status Ring Board
Holder
Temporary placement holes
A1000
5 Installation Procedure
19