YASKAWA PROFIBUS-DP SI-P3 Technical Manual page 15

Install the Option
Remove the front covers of the drive before installing the option. Refer to the drive instruction manual for directions on
removing the front cover. Cover removal varies depending on drive size. This option can be inserted only into the CN5-A
connector located on the drive control board.
DANGER! Electrical Shock Hazard. Do not inspect, connect, or disconnect any wiring while the drive is energized. Failure to comply
will cause death or serious injury. Before servicing, disconnect all power to the equipment and wait for at least the time specified on the
warning label. The internal capacitor remains charged even after the drive is de-energized. The charge indicator LED will extinguish
when the DC bus voltage is below 50 Vdc. When all indicators are OFF, measure for unsafe voltages to confirm the drive is safe.
1.
Shut off power to the drive, wait the appropriate amount of time for voltage to dissipate, then remove the keypad
(D) and front covers (C, F).
Refer to the manual packaged with the drive for details on keypad and cover removal.
NOTICE: Damage to Equipment. Observe proper electrostatic discharge (ESD) procedures when handling the option, drive, and
circuit boards. Failure to comply could cause ESD damage to circuitry.
Figure 5
2.
Affix the LED label (E) in the appropriate position on the drive front cover (C).
Figure 6
YASKAWA ELECTRIC SIEP C730600 82D YASKAWA AC Drive Option SI-P3 Technical Manual
Figure 5 Remove the Keypad, Front Cover, and Terminal Cover
Figure 6 Affix the LED Label
5 Installation Procedure
C
D
F
C
E
ERR RUN
BF COMM
15