YASKAWA PROFIBUS-DP SI-P3 Technical Manual page 14

5 Installation Procedure
Properly connect all pins and connectors on the option and drive.
Failure to comply could prevent proper operation and damage equipment.
Confirm that all connections are correct after installing the option and connecting peripheral devices.
Failure to comply could damage the option.

Procedures for Installing and Wiring Options on a Drive
Procedures to install and wire the option are different for different drivel models.
Refer to Table 6 to check the procedures to install and wire the option on a drive.
Product Series
A1000
U1000
Z1000U
GA500
GA700
GA800
<1> Use the option card installation case manual to install the option on GA500 drives.

Procedure A
This section shows the procedure to install and wire the option on a 1000-series drive.
Prepare the Drive for the Option
1. Correctly wire the drive as specified by the manual packaged with the drive.
2. Make sure that the drive functions correctly.
Refer to Figure 4 for an exploded view of the drive with the option and related components for reference in the
installation procedure.
Figure 4
M
L
K
J
A – Insertion point for CN5
B – Option card
C – Front cover
D – Keypad
E – LED label
F – Terminal cover
G – Removable tabs for wire routing
H – Included screws
I – Ground wire
14
Table 6 Procedures for Installing and Wiring Options on a Drive
Procedures for Installing and Wiring
I
H
Figure 4 Drive Components with Option
YASKAWA ELECTRIC SIEP C730600 82D YASKAWA AC Drive Option SI-P3 Technical Manual
NOTICE
Options on a Drive
Procedure A
Procedure A
Procedure A
<1>
Procedure B
Procedure B
A
B
G
J – Drive grounding terminal (FE)
K – Connector CN5-A
L – Connector CN5-B
(Not available for communication
option installation.)
M – Connector CN5-C
(Not available for communication
option installation.)
Page
C
D
E
ERR RUN
BF COMM
F
14
14
14
–
18
18