YASKAWA PROFIBUS-DP SI-P3 Technical Manual page 18

5 Installation Procedure

Procedure B
This section shows the procedure to install and wire the option on a GA700 or GA800 drive.
Prepare the Drive for the Option
1. Correctly wire the drive as specified by the manual packaged with the drive.
2. Make sure that the drive functions correctly.
Refer to Figure 11 for an exploded view of the drive with the option and related components for reference in the
installation procedure.
Figure 11
A – Insertion point for CN5 connector
B – SI-P3 option
C – Included screws
D – Drive front cover
E – LED label
F – Keypad
G – LED Status Ring board
Install the Option
Remove the front cover of the drive before you install the option.
Refer to the drive manual for information about how to remove the front cover. Different drive sizes have different cover
removal procedures.
You can only install this option into the CN5-A connector on the drive control board.
DANGER! Electrical Shock Hazard. Do not inspect, connect, or disconnect any wiring while the drive is energized. Failure to comply
will cause death or serious injury. Before servicing, disconnect all power to the equipment and wait for at least the time specified on the
warning label. The internal capacitor remains charged even after the drive is de-energized. The charge indicator LED will extinguish
when the DC bus voltage is below 50 Vdc. When all indicators are OFF, measure for unsafe voltages to confirm the drive is safe.
1.
Affix the LED label (E) in the appropriate position on the drive front cover (D).
Figure 12
18
J
I
H
G
Figure 11 Drive Components with Option
Figure 12 Affix the LED Label
YASKAWA ELECTRIC SIEP C730600 82D YASKAWA AC Drive Option SI-P3 Technical Manual
A1000
A
B
C A1000
D
H – Connector CN5-A
I – Connector CN5-B
(Not available for communication
option installation.)
J – Connector CN5-C
(Not available for communication
option installation.)
E
D
A1000
E
F