YASKAWA PROFIBUS-DP SI-P3 Technical Manual page 17

5.
Select the proper PROFIBUS-DP dedicated communication cable according to
Route the option wiring inside the enclosure as shown in
covers will easily fit back onto the drive.
Users may also choose to route the option wiring through openings on the front cover of some models. Remove
the perforated tabs on the left side of the front cover as shown in
on these models.
Refer to the Peripheral Devices & Options section of the drive instruction manual for more information.
Figure 9
A
A – Route wires through the openings
provided on the left side of the front
cover.
<1> The drive will not meet Enclosed wall-mounted type (IP20/UL Type 1) requirements if wiring is exposed outside
the enclosure.
6.
Firmly connect the PROFIBUS-DP communication cable to option communication connector CN4.Install
PROFIBUS-DP communications cables apart from main-circuit wiring and other electrical and power lines.
Ensure the cable end is firmly connected (see
page 22 for details.
7.
Reattach the drive front covers (C, F) and the keypad (D).
NOTICE: Do not pinch cables between the front covers and the drive. Failure to comply could cause erroneous operation.
Figure 10
8.
Set drive parameters in
address unique to the network.
YASKAWA ELECTRIC SIEP C730600 82D YASKAWA AC Drive Option SI-P3 Technical Manual
<1>
Figure 9 Wire Routing Examples
Figure 10 Replace the Front Covers and Keypad
Table 9 for correct option performance. Be sure to set parameter F6-30 to a node
Figure 9-B. Take proper precautions so that the front
Figure
B – Use the open space provided inside
the drive to route option wiring.
Figure 19). Refer to Communication Cable Specifications on
C
F
5 Installation Procedure
Table 7 and Table
9-A to create the necessary openings
B
D
8.
17