YASKAWA PROFIBUS-DP SI-P3 Technical Manual page 16

5 Installation Procedure
3.
Insert the option card (B) into the CN5-A (K) connector on the drive and fasten it into place using one of the
included screws (H). Tighten the screw to 0.5 to 0.6 Nm (4.4 to 5.3 inlb).
Figure 7
4.
Connect one end of the ground wire (I) to the ground terminal (J) using one of the remaining provided screws
(H). Connect the other end of the ground wire (I) to the remaining ground terminal using the last remaining
provided screw (H).
Figure 8
Note: The drive has only two ground terminal screw holes (J). Two ground wires should share the same ground terminal when
connecting three options.
16
K
Figure 7 Insert the Option Card
J
I
Figure 8 Connect the Ground Wire
YASKAWA ELECTRIC SIEP C730600 82D YASKAWA AC Drive Option SI-P3 Technical Manual
B
H
H