Declaration Of Icons; Intended Use - Roland Double Sheet Detector R1000 Series Manual

B0069991 / Rev. 1.7
Only authorized personnel should be allowed to make changes to the unit and perform cable
connections especially the power supply.
Should it be necessary, e.g. in case of service or repair, to make measurements within the unit,
then all customary accidents prevention procedures should be observed. Only professional
electrical tools should be used.
1.2

Declaration of icons

1.3

Intended use

Flexible Manufacturing Systems in the sheet processing industry require reliable Double Sheet
Control systems in order to protect presses and other sheet processing machines against damage
caused by feeding multiple sheets.
The Double Sheet Detector R1000 I20 was specifically developed for this technical environment.
Depending on the application (type of material, thickness, sensor gap) the I20 can be used with up
to four pairs of sensors. The reliable function of the Double Sheet Detector depends therefore most
importantly on the selection of the correct sensors and the mounting of the sensors.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector-series I20
The factory pre-settings – especially the upper / lower limit values – have
Note
been chosen such that an optimal machine protection is ensured.
Diverging settings can impair the machine protection.
Safety advice for persons with cardiac pacemakers!
Persons with cardiac pacemakers are to stay away from the sensors!
The strong magnetic / electromagnetic fields of the sensors can cause malfunction
of cardiac pacemakers and other such apparatus!
Warning - general dangers!
Reference to imminent hazards, which can result in severe bodily harm or death.
Warning - dangers by high voltage!
Reference to imminent hazards due to electricity, which can result in severe bodily
harm or death.
Attention - Damage of construction units!
Reference to a potential imminent situation, which can result in damage to the
product or environs.
Note
Useful reference to an application or deepening information.
Manual
Safety advices
7