General Information Regarding The Configuration; Changing, Setting-Up Or Checking The Configuration - Roland Double Sheet Detector R1000 Series Manual

Start-up
7.5

General information regarding the configuration

The following rules apply to the operation in the configuration mode:
• The configuration mode is activated (while in measurement mode) by pressing the MENU
• The configuration mode is terminated or cancelled by pressing the MENU key.
• The selected / set parameters can be changed when the items are blinking in the display.
• The selected / set parameters are activated by pressing the ENTER key.
7.6

Changing, setting-up or checking the configuration

In order to select, set-up or check the system / program parameters, press the MENU key.
Here either reviewing or changing the configuration can be selected.
Configuration review:
configuration
review
Fig. 35: Indication after calling-up the menu
Configuration change:
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
76
Double Sheet Detector-series I20
The correct configuration depends on the communication with the PLC,
Note
on the measurement task and the connected components.
The systems info and bus info is displayed by pressing the ENTER key in
Note
the base menu (compare also system parameter 27).
The program / adjust / system parameters cannot be changed.
The measurement mode is not interrupted.
All program / adjust / system parameters can be changed after
entering the password. The following menu option is shown.
Manual
B0069991 / Rev. 1.7
key.