Roland Double Sheet Detector R1000 Series Manual page 45

B0069991 / Rev. 1.7
S
N
S
Fig. 20: Sensor mounting, top view (*Sensor)
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector-series I20
> 50 cm
S S S
N N N
N N N
S S S
The sensors should be mounted wherever possible 50 cm after the
Note
start of the magnetic tape drive.
Note If electromagnets are used in the conveyor belts, the
electromagnets must be supplied with DC voltage / current. The
residual ripple of the supply voltage must not exceed 5%. The
supply voltage or the supply current of the electromagnets is not be
clocked during the measurement, as this can affect the
measurement result.
.
Manual
S S
N N
V
N N
S S
Mounting
45