Roland Double Sheet Detector R1000 Series Manual page 77

B0069991 / Rev. 1.7
configuration
change
Fig. 36: Selecting the configuration mode
Available configuration modes:
• Configuration program parameter
• Configuration adjustment parameters
• Configuration system adjust
• Data backup
• Firmware update
Program parameters are application specific adjustments (e.g. input of nominal sheet thickness).
Adjustment parameters are parameter, which are only valid for this individual system; they cannot
be transferred to other systems.
System parameters are general adjustments (e.g. language).
For changing parameters, the password must be entered.
password
xxxx
Fig. 37: Password request
Each blinking digit can be changed with the arrow keys and confirmed with ENTER. After having
entered the correct password, the following menu appears for the adjustment of the configuration
mode. The password is factory set to "0000".
If the entered password is incorrect then the cursor returns to the first digit of the password and the
input must be repeated. The input of the password can be aborted by pressing the MENU button.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector-series I20
After exiting the configuration mode the password remains active for five
Note
minutes. Thus other configuration adjustments can be made, without re-
entering the password. If no key is pressed for five minutes (while in the
menu level), then the program changes to the measurement mode.
A fault is generated if PLC commands are executed while entering the
Note
password or changing parameters.
Manual
Start-up
77