Roland Double Sheet Detector R1000 Series Manual page 90

Start-up
System parameter 3: Selecting the dimensions for the display (mm / inch).
When changing the measurement dimensions, then the sheet metal thicknesses of the stored
program parameters are also converted into the new dimension.
System Parameter:
display value in
Fig. 77: Selecting the dimension for the display
Possible choices:
• mm / inch
• %mm / %inch
System parameter 4: not available
System parameter 5: Setting the display time
System Parameter:
display time
2.0 s
Fig. 78: Setting the display time
The maximal measured values (peak values) will be indicated for the time specified here (holding
time). This time is only for the display.
System parameter 6: not available
System parameter 7: not available
System parameter 8: Deleting all measuring programs.
System Parameter:
clear prog. param.
Fig. 79: Deleting of measuring programs
Possible choices:
• yes
• no
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
90
Double Sheet Detector-series I20
3
mm
only if system type is "standard".
only if system type is not "standard".
5
8
no
The deletion cannot be undone.
Attention
Manual
B0069991 / Rev. 1.7