Roland Double Sheet Detector R1000 Series Manual page 79

B0069991 / Rev. 1.7
Program parameter 4: Specifying the material of the sheets to be measured.
Program Parameter: 4
Material
ferrous steel
Fig. 41: Selection of material to be measured
Possible choices:
• Fe (ferrous):
• NF (non-ferrous):
• NF?:
Program parameter 5: Setting the percentage threshold of the lower limit value.
Program Parameter: 5
lower threshold
80%
Fig. 42: Adjusting the upper limit
Value range: between 0% and 99% of the nominal value, with simultaneously displaying the
absolute limit value.
Program parameter 6: Setting the percentage threshold of the upper limit value.
Program Parameter: 6
upper threshold
120%
Fig. 43: Adjusting the lower limit
Value range: between 100% and 180% of the nominal value, with simultaneously displaying the
absolute limit value.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector-series I20
Magnetic material.
Nonmagnetic material (e.g. Aluminum, austenitic Stainless Steel)
with known conductivity.
Nonmagnetic material (e.g. Aluminum, austenitic Stainless Steel)
with unknown conductivity. During Teach-In, the system determines
by itself the conductivity of the material between the sensors.
The user will be asked whether the conductivity is to be determined
now or at a later time.
6.608 mm
12.390 mm
Manual
Start-up
79