Table of Contents
Advertisement
SKREEM
ROLLING CODE FAILURE —
TEST
2
Turn the ignition on.
With the DRBIII , select Engine system from the main menu.
Display and record the Vehicle Identification Number.
NOTE: Ensure that a VIN has been programmed into the PCM. If a VIN is not
displayed, attempt to program the PCM with the correct vehicle VIN before
continuing.
Does the VIN recorded from the PCM match the VIN of the vehicle?
Yes → Go To 3
→ Perform the PCM replaced to update the VIN in the PCM.
No
3
Turn the ignition off.
Replace and program the Sentry Key Remote Entry Module in accordance with the
Service Information.
Turn the ignition on.
With the DRBIII , display and clear all PCM and SKREEM DTC's.
Perform 5 ignition key cycles leaving the ignition key on for 90 seconds per cycle.
With the DRBIII , check for SKREEM DTCs.
Does the DRBIII display the same DTC?
Yes → Replace and program the Powertrain Control Module in accor-
→ The repair is complete.
No
4
Turn the ignition off.
Note: Visually inspect the related wiring harness. Look for any chafed,
pierced, pinched, or partially broken wires.
NOTE: Visually inspect the related wiring harness connectors. Look for
broken, bent, pushed out, or corroded terminals.
Note: Refer to any Technical Service Bulletins (TSB) that may apply.
Were any problems found?
Yes → Repair wiring harness/connectors as necessary.
→ Test Complete.
No
Continued
ACTION
Perform SKREEM VERIFICATION TEST - VER 1A.
dance with the Service Information.
Perform SKREEM VERIFICATION TEST - VER 1A.
Perform SKREEM VERIFICATION TEST - VER 1A.
Perform SKREEM VERIFICATION TEST - VER 1A.
304
APPLICABILITY
All
All
All
Advertisement
Table of Contents
