Table of Contents
Advertisement
DRIVEABILITY - NGC
P2096-DOWN STREAM FUEL SYSTEM 1/2 LEAN —
TEST
1
NOTE: Check the vehicle repair history. If the O2 has been replace ensure
that the O2 sensor was properly installed and meets OEM specification.
NOTE: Check for contaminants that may have damaged the O2 Sensor:
contaminated fuel, unapproved silicone, oil and coolant.
Ignition on, engine not running.
With the DRBIII , read DTCs and record the related Freeze Frame data.
Is the Good Trip Counter displayed and equal to zero?
Yes → Go To 2
→ Refer to the INTERMITTENT CONDITION symptom in the
No
2
Turn the ignition off.
WARNING: To avoid personal injury from the exhaust system being hot,
allow the exhaust to cool down to a safe temperature before performing a
physical inspection.
Visually and Physically inspect the for holes, cracks and blockage in the exhaust
system.
Is the exhaust system is good condition?
Yes → Go To 3
→ Repair or Replace as necessary.
No
3
Check for any of the following conditions/mechanical problems.
AIR INDUCTION SYSTEM - must be free from leaks.
ENGINE VACUUM - must be at least 13 inches in neutral
ENGINE VALVE TIMING - must be within specifications
ENGINE COMPRESSION - must be within specifications
ENGINE EXHAUST SYSTEM - must be free of any restrictions or leaks.
ENGINE PCV SYSTEM - must flow freely
TORQUE CONVERTER STALL SPEED - must be within specifications
POWER BRAKE BOOSTER - no internal vacuum leaks
FUEL - must be free of contamination
FUEL INJECTOR - plugged or restricted injector; control wire not connected to
correct injector
Are there any engine mechanical problems?
Yes → Repair as necessary.
→ Go To 4
No
4
Ignition on, engine not running.
Disconnect the O2 Sensor harness connector.
With the DRBIII , monitor the O2 Sensor voltage.
The O2 Sensor voltage should read 5.0 volts on the DRBIII with the connector
disconnected.
Using a jumper wire, jump the O2 Signal circuit to the O2 Return circuit at the O2
Sensor harness connector.
NOTE: The voltage should drop from 5.0 volts to 2.5 volts with the jumper
wire in place.
Did the O2 Sensor volts change from 5.0 volts to 2.5 volts?
Yes → Replace the O2 Sensor
→ Go To 5
No
ACTION
Driveability category.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
Perform POWERTRAIN VERIFICATION TEST VER - 5 - NGC.
278
Continued
APPLICABILITY
All
All
All
All
Advertisement
Table of Contents
