SSANGYONG RODIUS 2004.09 Manual page 85

(6) DIAGNOSIS PROCEDURES (7) TROUBLESHOOTING
1.
The wiper should not operate one cycle when turning the wiper switch to "AUTO"
from "OFF" position or IGN2 while the wiper switch is in "AUTO" position.
- When the IGN2 with the wiper switch "AUTO"
to remind a driver that the wiper switch is in "AUTO"
- When the wiper switch is turned to "AUTO"
It always operates one cycle for the initial operation, however, the wiper does not operate
afterwards to prevent the wiper blade wear if not raining when turning the wiper switch to
"AUTO" from "OFF". However, the wiper operates up to 5 minutes after rain stops. If
this function does not occur, check No. 1 pin. If the pin is normal, check the wiper relay
related
terminals in ICM box.
2. It rains but the system does not work in "AUTO" position.
-
Check whether the wiper switch is in "AUTO" position.
-
Check the power to sensor. Check the conditions of pin 3 (Ground) and pin 4 (IGN).
- Check the wiper relay for defective.
3. The wiper operates 3 or 4 times with high speed abruptly.
Check whether the variable resistance knob on the wiper switch is set in "FAST".
"FAST" is the highest stage of sensitivity and very sensitive to small amount of rain
drops. Therefore, change the knob to low sensitivity.
4. The wiper operates continuously even on the dry glass.
- Check the wiper blade for wear. If the wiper blade cannot wipe the glass uniformly and
clearly, this problem could be occurred. In this case, replace the wiper blade with new
one.
- Check whether the variable resistance knob on the wiper switch is set in "FAST".
The "FAST" is the highest stage of sensitivity and very sensitive to small amount of
rain drops. Therefore, change the knob to low sensitivity.
5. The wiper responses are too fast or slow.
Check whether the variable resistance knob on the wiper switch is set in "FAST"
"SLOW".
Notify that the customer can select the sensitivity by selecting the variable resistance value.
And, select a proper stage.
0-41
8610-11
position, the wiper operates one cycle
position.
from OFF, the wiper operates one cycle.
The
or
CIRCUIT
RODIUS 2004.09