Table of Contents
Advertisement
3) CIRCUIT DESCRIPTION
(1) DESCRIPTION OF BURGLAR ALARM FUNC
A. Armed mode activation requirements
-
The "LOCK" output is "ON" when receiving the "LOCK" signal from transmitter
while the ignition key is removed and all doors are closed. The armed mode is activated
when the door lock switch is locked (theft deterrent horn output: once, hazard relay
output: twice).
-
The theft deterrent horn and hazard relay outputs are "ON"
"LOCK" signal from the remote control key again in armed mode (theft deterrent
horn output: once, hazard relay output: twice).
-
When receiving "LOCK" signal from the remote control key while any of doors is
not closed, only the "LOCK"
output can be done and then activates the armed
ready mode (without theft deterrent horn and hazard warning flasher). At this moment, if
the ignition key is in the ignition switch, the door unlock switch is turned "ON"
door lock switch is unlocked (after 0.6 seconds), cancels the armed mode and activates
the normal mode. However, in these cases, if closing the door and locking the door lock
switch, the theft deterrent horn outputs once and the hazard warning flasher outputs
twice and then activates armed mode.
-
When the door is not opened or the ignition key is not inserted into ignition switch for 30
seconds after receiving "UNLOCK"
armed mode (RELOCK operation). Also, at this moment, the system outputs the theft
deterrent horn and hazard warning flasher. 5. The armed mode will not be activated
except above conditions.
Ex) The armed mode will not be activated when the door is locked by the ignition key.
when receiving the
or th
signal, outputs "LOCK" and then activates
0-69
8510-26
CIRCUIT
RODIUS 2004.09
Hide quick links:
Advertisement
Chapters
Table of Contents
