SSANGYONG RODIUS 2004.09 Manual page 77

C. Fuel level gauge
The fuel level gauge displays the resistance value of the float on the fuel sender in the fuel
tank through a pointer.
Note that this vehicle doesn't have a service hole for checking the fuel sender connector in
the fuel tank.
The fuel sender and its connector can be checked and replaced only when the fuel tank is
removed. The power supply and resistance value should be measured at the connector in
front of the fuel sender (refer to wiring diagram).
When the power supply and output resistance are normal, the float operation by fuel level
may be defective if so, replace the fuel sender.
Tolerance and resistance value by indicating angle
▶
This table shows the tolerance and resistance value changes by fuel level in normal
conditions. Therefore, the differences that can be occurred by the road conditions and
fuel fluctuations are ignored.
D. Coolant temperature gauge
The coolant temperature gauge displays the coolant temperature with a pointer.
The angle of pointer that changes by coolant temperature is as shown below.
- Measurement of coolant temperature sensor resistance
Measure the resistance between the terminal and the ground with an ohmmeter and
replace if the resistance is out of specified range.
- Resistance value by coolant temperature:
- When the resistance value by coolant temperature is within the specified range,
check thermostat, water pump, radiator related coolant circuit for normal operation.
Also, check the wiring harnesses and connectors for proper connection.
20℃ - 2449W ± 5 %
50℃ - 826W ± 5 %
80℃ - 321W ± 5 %
100℃ - 112W ± 5 %
E. TRIP ODOMETER (TRIP A, TRIP B) AND
ODOMETER
▶Reset button
- Press and hold (over 1 sec.)
Trip odometer "TRIP A" and "TRIP B" will be reset to 0. (However, only the
corresponding driving range will be set to 0.)
- Press shortly (between 0.1 ~ 1 sec.)
The mode changes in order as shown in the figure.
0-33
8010-01
CIRCUIT
RODIUS 2004.09