SSANGYONG RODIUS 2004.09 Manual page 211

03-6
1881-01
8) Draining the Water From Fuel Filter for General Area
1. Fuel filter
2. Priming pump
3. Water separator
1. Place the water container under the fuel
filter & water separator.
2. Disconnect the connector under the drain
plug of the water separator.
3. Turn both drain plugs to "A"
to drain the water.
4. Wait until a certain amount of fuel gets
out from the port, then turn the both drain
plugs to "B" direction to tighten it.
ENGINE FUEL SYSTEM
RODIUS 2004.09
4. Drain plug
5. Connector
direction
- Be careful not to be injured by
surrounding equipment
working procedures.
4. Engage the connector under the drain
plug and press the priming pump until it
becomes rigid.
5. Start the engine and check the onditions.
6. Clear the fault code of ECU with SCAN-
Tools.
- If the priming pump is not properly
operated, air may get into the fuel line.
It may cause starting problem or fuel
system problem. Make sure to perform
the job in step 4.
during the