SSANGYONG RODIUS 2004.09 Manual page 470

2. ON-VEHICLE SERVICE
1) Service Precautions
(1) Electronic system service precautions
Take care to avoid electronic brake control module (HECU) circuit overloading. In testing for
opens or shorts, do not ground or apply voltage to any circuit unless instructed to do so by the
diagnostic procedure.
Test circuits only with a high-impedance multi-meter. Never remove or apply power to any
control module with the ignition switch in the ON position. Always turn the ignition to the OFF
position before removing or connecting battery cables, fuses or connectors.
(2) General service precautions
Disconnect the HECU connector before performing any vehicle welding work using an electric
arc welder.
Do not attempt to disassemble any component designated as nonserviceable. The hydraulic
modulator and the HECU can be seperated. (There is however no access to repair the each
components.)
(3) Bleeding system
Replacement modulators are shipped already filled and bled. In normal procedures requiring
removal of the modulator, such as to replace the HECU, air will not enter the modulator, and
normal bleeding will be all that is needed.
If air enters the hydraulic modulator, or if an unfilled modulator is installed, use the brake
bleeding program in the scan tool to bleed the modulator. Manual bleeding of the hydraulic
modulator is not possible.
- Brake Fluid may irritate eyes and skin. In case of contact, take the following actions:
Eye contact - rinse thoroughly with water.
·
Skin contact - wash with soap and water.
·
Ingestion - consult a physician immediately.
·
- To help avoid personal injury due to poor braking. DO NOT Tap into the vehicle's
brake system to operate a trailer brake system.
10-9
4892-01
ABS
RODIUS 2004.09